Electrical Connection - Whirlpool DISHWASHERS Use And Care Manual

When cycle is finished
1. Turn hot water off. (This can be done after the
last rinse.)
2. Press the red button on the connector to
release the water pressure.
3. Lift slightly on the hose connector while pulling
down the locking collar. Pull down on the
connector.
4. Empty any remaining water from the
connector by turning the connector
upside-down.
5. Unplug power supply cord and return to
storage compartment.
6. Return hoses to storage compartment.
Hose connection
Electrical connection
A power supply of 120 votts, 60Hz AC, 15 or 20
amps, is required. For your personal safety, this
appliance must be grounded. This appliance is
equipped with a power supply cord having a
3-prong grounding plug. To minimize possible
shock hazard it must be plugged into a mating
3-prong grounding type wall receptacle,
grounded in accordance with the National
Electrical Code and local codes and ordinances.
If a mating wall receptacle is not available, it is
the responsibility and obligation of the customer
to have a properly grounded 3-prong wall
receptacle installed by a qualified electrician.
Do not, under any circumstances,
remove the power supply cord ground
prong.
3.prong
grounding
Power supply
cord
I
3.prong
grounding
type wall
receptacle
Converting to built-in
Your Whirlpool Portable Dishwasher can be
converted to a built-in (undercounter) model by
using conversion kit No. 4317856. The kit is
available at your Whirlpool dealer or authorized
WhirlpoolSM service company. Instructions are
included with the kit.
21