The Canceudrain Pad; Control Panel Lock-Out Feature; Adjusting The Beeping; Sound - Whirlpool 9400 Series Use And Care Manual

The CANCEL/DRAIN pad
Im The CANCEL/DRAIN pad allows you to cancel a cycle, to clear the signal lights or to
make a new selection.
I- 1
l
Press CANCEL/DRAIN while the dish-
* Press CANCEUDRAIN again to start a
washer is washing to start a 2 minute drain.
2 minute drain, if there is still water in the
(If the dishwasher has not been started or
dishwasher.
is not washing, it will clear the display.) NOTE: A small amount of water remaining
l
Press CANCEUDRAIN again to stop the
in the dishwasher is normal. See page 27.
drain.
Control panel lock-out feature
This feature lets you lock-out the function of the control pads (except to cancel or pause a
cycle that is running). When the control panel is locked-out, the dishwasher cannot be started
and a running cycle cannot be changed.
To use the lock-out feature
1. Press and hold the OPTIONS and DELAY
PRESS
YOU SEE
pads until the CLEAN signal light flashes.
2. Release the pads. The CLEAN signal light
will stop flashing.
To turn off the lock-out
feature
1. Press and hold the OPTIONS and DELAY
Dads until the CLEAN sianal liaht turns on
PRESS
YOU SEE
and stays on.
1 -
2. Release the pads. The CLEAN signal light
will turn off.
Adjusting the beeping sound
Each time a control pad is pressed, a single "beep" sound is made. A double beep means one
of the extra features was selected (such as control panel lock-out) or the wrong control pad
was pressed.
To turn off the beep
1. Press and hold the OPTIONS pad until the
CLEAN signal light flashes.
PRESS
YOU SEE
2. Release the pad. The CLEAN signal light
will turn off.
NOTE: A power failure will reset this feature.
You will have to repeat the above steps.
To turn the beep back on
1. Press and hold the OPTIONS pad until the
CLEAN signal light turns on and stays on.
PRESS
2. Release the pad. The CLEAN signat light
will turn off.
YOU SEE