Whirlpool 920 Series Use And Care Manual page 27

4. Place a shallow pan under the water
supply valve. Then, use a wrench to
disconnect the water inlet from the
water supply valve. Separate the water
inlet from the water supply valve and
drain water into the pan.
5. Remove the spring clamp from the
water outlet and separate from the
water supply valve; drain water into
pan.
6. Reconnect both water inlet and water
outlet to the water supply valve.
7. Empty the pan and reposition it under
the water pump.
8. Remove the clamp and disconnect the
drain hose from the water pump; drain
water into pan.
9. Reconnect drain hose to the water
pump, being sure to position the clamp
over the connection.
10. Replace the lower access panel.
NOTE: If your dishwasher is connected to
a garbage disposal, do not run water into
the sink after winterizing. This could cause
water to refill the drain hose on your
dishwasher.
Reconnecting your dishwasher
1. Remove the 4 screws on the lower
access panel and remove lower
access panel.
2. Turn on the water supply to dishwasher.
3. Reconnect power or plug in dishwasher.
4. Run dishwasher through a complete
cycle and check for leaks.
5. Replace lower access panel.
CARING FOR YOUR DISHWASHER
Built-in models
Water outlet
Water supply
valve
Portable models
Water outlet
Water supply
valve
Water pump
Spring
and motor
clamps
Water Drain
inlet hose
Screw
Water pump
Spring
clamp
and motor
clamp
Water inlet
Drain hose
27