Eureka Limited Warranty Information - Eureka AirSpeed MyVac Owner's Manual

This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum suddenly shuts off, proceed as follows:
1) Push the power switch to off and unplug the vacuum.
2) Check the vacuum for a possible source of overheating such as a full dust cup, blocked hose or clogged filter. If these conditions are found, fix them
and wait at least 30 minutes before attempting to use the vacuum.
3) After the 30 minute period, plug the vacuum back in and turn on the switch. If the vacuum still does not work, call the Eureka customer service helpline.
Problem
Motor will not start.
Vacuum does not clean
carpet or bare floor.
No suction at the
end of hose.
Turbo nozzle will not turn.
Vacuum is hard
to push.
Burning smell; brush roll
will not turn.
Cord will not rewind fully
(on cord rewind models).
6
Eureka Customer Service HELPLINE 1-800-282-2886
Problem solving
Make sure vacuum is turned off and power cord is unplugged.
N O T I C E : Thermal cut-off
Cause
Power plug
Power switch
Thermal cut-off
Dust bag or dust cup/filters.
Air path selector
Belt
Hose
Carpet height setting
Bare floor setting
Dust bag or dust cup/filters.
Air path selector
Hose
Rotating brush
Vacuum height setting
Belt
Belt
Cord tangles
• Push plug securely into outlet, try another outlet or
check circuit breaker.
• Step on power switch to turn vacuum on.
• See detailed "thermal cut-off" instructions above.
• Replace dust bag or empty dust cup.
• Clean or replace filters regularly to maintain suction.
• If picking up fine dust, the dust bag or dust cup may not look full, but a fine
substance tends to reduce suction when it blocks air flow through the bag,
filter and screen.
• Make sure filters, dust bag or dust cup are installed properly.
• Turn selector knob to 'floors.'
• Replace a worn, cut or out of shape belt. Page 4
• Remove clogs from the hose that restrict the airflow. Make sure hose is
replaced into hose retainer. Page 4
• Turn height adjustment knob to another position.
• For bare floor cleaning, turn height adjustment knob to bare floor position.
• Replace dust bag or empty dust cup.
• Clean or replace filters regularly to maintain suction.
• If picking up fine dust, the dust bag or dust cup may not look full, but a fine
substance tends to reduce suction when it blocks air flow through the bag,
filter and screen.
• Make sure filters, dust bag or dust cup are installed properly.
• Turn selector knob to 'tools.'
• Remove clogs from the hose that restrict the airflow. Make sure hose is
replaced into hose retainer. Page 4
• Check turbo nozzle for debris. Page 5
• If no suction at end of hose, turn selector knob to 'tools.'
• Adjust knob to a higher position.
• Replace a worn, cut or out of shape belt.
• Check brush roll for debris. Page 4
• Replace broken or out of shape belt. Page 4
• Pull out entire cord removing any kinks, and push button to rewind completely.
Solution
www.eureka.com