Selecting The Projector You Want To Operate; Using Multiple Projectors - Epson EB-U50 User Manual

Using Multiple Projectors

d
Use the arrow buttons to select the identification number you want to
use for the projector. Then press [Enter].
e
Press [Menu] or [Esc] to exit the menus.
f
Repeat these steps for all the other projectors you want to operate from
one remote control.

Selecting the Projector You want to Operate

After setting the projector's ID, select the ID for the projector you want to
operate using the remote control.
a
Aim the remote control at the target projector and press the [ID]
button.
The current Projector ID is displayed on the projected screen. It
disappears after about 3 seconds.
b
While holding the [ID] button, press the number button that matches
the ID of the projector you want to operate.
The projector you want to operate is selected.
• When you select [0/All] on the remote control, you can
a
operate all projectors regardless the Projector ID setting.
• When you set the Projector ID setting to Off, you can operate
the projector using the remote control whichever ID you select
on the remote control.
• The projector ID setting is saved in the remote control. Even if
the remote control batteries are removed to replace them and
so on, the saved ID setting is retained. However, if the batteries
are left out of the remote control for an extended period, the
ID returns to its default setting (0/All).
74