LG G Series Owner's Manual page 21

SMART DIAGNOSIS
Using Smart Diagnosis
FOR EXTERNAL CONTROLLER MODEL
Smart diagnosis function is...
Use the function to contact the service center and receive precise diagnosis when the refrigerator
malfunctions or fails. Use it only to connect to the consultant and do not use it in normal times.
How to use the function
1. Close all refrigerator doors, and press
and hold display lock button to make it
locked state.
If the display is already in locked state, press
and hold lock button to reset the lock and
press and hold the lock button again to make
it locked state.
CAUTION
If it passes 5 minutes in locked state, smart
diagnosis function will not be activated, so
be careful.
2. Press and hold fridge temperature button
for 3 seconds or longer.
(All display screens will be turned off,
and in a while, 3 will be displayed on the
fridge temperature display part.)
3. Open all refrigerator compartment and
freezer compartment doors and place the
telephone near the speaker hole at the
top right side.
Check if the speaking side (microphone) of
the telephone is toward the speaker hole.
4. Do not take away the telephone while
data is being transmitted.
During the data transmission for smart
diagnosis, wait with the telephone placed
near the speaker hole at the top right side.
The remaining time for data transmission is
displayed on the display screen.
(Only for applied models)
TM
21
CAUTION
The transmission sound may be irritating.
Do not take away the telephone until the
sound stops for good diagnosis.
5. A f t e r t h e c o m p l e t i o n o f t h e d a t a
transmission, listen to the explanation of
the consultant about the result of the
smart diagnosis.
When the data transmission is completed,
along with the display of the data transmission
c o m p l e t i o n , t h e r e f r i g e r a t o r w i l l b e
automatically turned off and on a few seconds
later.
Listen to the explanation of the consultant
about the result of the analyzed diagnosis and
follow the instructions.
NOTE
Position the phone so that its microphone is
Ÿ
aligned with the speaker hole.
The Smart Diagnosis
Ÿ
after around three seconds.
Do not take the phone off the speaker hole
Ÿ
while the data is transmitted.
Hold the phone to the upper right speaker
Ÿ
hole and wait while the data is transmitted.
The data transfer sound may be harsh to the
Ÿ
ear while the Smart Diagnosis data is being
transmitted, but do not take the phone off the
speaker hole for accurate diagnosis until the
data transfer sound has stopped.
When the data transfer is complete, the
Ÿ
transfer completion message is displayed
and the control panel is automatically turned
off and then on again after a few seconds.
After the customer information centre
explains the diagnosis result.
The Smart Diagnosis function depends on
Ÿ
the local call quality.
The communication performance will
Ÿ
improve and you can transmit a better signal
if you use a land line home phone.
If the Smart Diagnosis data transfer is poor
Ÿ
due to poor call quality, you may not receive
the best Smart Diagnosis service.
TM
sound is generated
TM
TM
TM
TM