Regency MABP27 Instructions

You will need a Phillips Head Screw Driver and a Tape Measure to Assemble.
Hardware :
A: Screws(28)
A
Parts :
B: Adjustable Leg (4) • C: Table Top (may vary) • D: Allen Wrench
B
D
STEP 1A (Square Table Top): Place Table Top(C) on a clean flat surface with
desired table finish face down. Position Adjustable Legs(B) as shown in Figure A.
Then, attach assembled Legs to Table Top using 7 Screws(A) per Leg.
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
Any problems or questions call Regency Office Furniture at 1-866-816-9822 or email customerservice@regencyof.com
·
MABP27 Kee Adjustable Table Leg INSTRUCTIONS
You will need 2 person(s) for this assembly.
C
C
Figure A
*NOTE: Place Legs at
least 1-inch away from
Edge Table*