2.2
Notes before use
Before using your device, please read through the following instructions
Use only the power adapter that came with your device. Using a different power
⚫
adapter may cause damage.
The AC adapter is designed for use with the RTC-1200 only.
⚫
This product is intended to be supplied with a Listed Power Adapter or DC
⚫
power source, rated 19Vdc, 3.42A minimum, Tma = 40°C. Please contact AAEON
for further assistance.
Using a power outlet is the best way to charge your device (refer to section 1.2
⚫
for the adapter's voltage output and acceptable input)
When using the device for the first time, fully charge the battery for up to 8
⚫
hours. If the device is inactive, charging the battery once per month is
recommended to prevent deterioration.
There are two batteries in the RTC-1200: both batteries can be monitored at the
⚫
title bar). Charge the device once Battery 1 drops below 20%
Always allow your battery to be fully charged before use. Calibrating the battery
⚫
before use is highly recommended.
To prolong battery life, allow a fully charged battery to discharge more than
⚫
95% before recharging.
Ensure that the battery cover is properly secured by manually pushing the pin to
⚫
lock position.
The RTC-1200 CANNOT be charged via an USB connection.
⚫
The IP65 waterproof protection may get damaged when subjected to shocks
⚫
greater than levels tested in MIL-STD-810G Method 516.6 Procedure IV. The
protection may also be affected if the rubber connector fails to cover or close
firmly.
Chapter 2 – Getting Started
12