GMC 88960445 Installation Instructions Manual

Under Seat Storage
Tools Needed
3/8 inch Socket Wrench
7/8 inch Wrench
1/8 inch Allen Wrench
3/32 inch Allen Wrench
Installation Instructions
1. Lift seat bottom into the upright position. Pull on the strap to
release the seat and then lift it. To lift the seat you may need
to give it a small push down on the cushion.
2. Install latch mechanism to seat base brackets. See Figure 1.
Unscrew the oval backing plate from latch mechanism. Align
the oval guide on the latch mechanism to the oval hole in the
inside of the seat bracket. Screw the oval backing plate onto
the latch mechanism on the outside of the seat bracket in the
vehicle. You may need to move the latch bracket forward to
get at the screws. The arm of the latch mechanism should be
to the front of the vehicle of the pin. Verify that the oval back­
ing plate aligns with the oval hole in the seat bracket.
FIGURE 1
Fit the divider to the truck. See Figure 2. Align the driver side
3.
of the divider to the seat bracket then snap the passenger side
into place. The divider has tabs that will fit in the inside front
of the seat brackets when in place. See Figure 3. Install the
retention brackets with the bolts, washers and 3/8 inch nuts
provided. Use the 2 inch long bolts for the LH (
1-1/2 inch long bolts for the RH (
retaining bracket to the LH (driver) side of the vehicle. See Fig
ure 4. Attach to the inside of the divider using the top two
bolts. It will be between the divider and the nuts. Torque to 10 ft-lbs
Nm) .
driver) side and the
passenger) side. Install the seat
FIGURE 2
FIGURE 3
FIGURE 4
( 1 3
Service Parts Operations
6200 Grand Pointe Dr., Grand Blanc, Ml 48439