Table of Contents
Advertisement
SYM
Ÿ Do not let the wire harness contact with
rotating, moving or vibrating components as
routing the harness.
Ÿ Keep wire harnesses far away from the hot
parts.
Ÿ Route wire harness to avoid sharp edges or
corners and also avoid the projected ends of
bolts and screws.
Ÿ Route harnesses so that they neither pull too
tight nor have excessive slack.
Do not extend
it too much.
1. GENERAL INFORMATION/TROUBLE DIAGNOSIS
Do not touch it.
Ÿ Protect wires or wire harnesses with electrical
tape or tube if they contact a sharp edge or
corner. Thoroughly clean the surface where
tape is to be applied.
Ÿ Secure the rubber boot firmly as applying it
on wire harness.
Ÿ Never use wires or harnesses which
insulation has been broken. Wrap electrical
tape around the damaged parts or replace
them.
Ÿ Never clamp or squeeze the wire harness as
installing other components.
Please do not clip or
squeeze the wire.
1-7
Advertisement
Table of Contents
