Setting The Ptzf Control - [Ptzf Control] Menu; [Ptzf Control] Tab - Sony SRG-XP1 Operating Instructions Manual

[Access limit]
Set an access limit to the camera.
[Enable]
Select the checkbox to enable the access
limit.
[Rule]
Set rules for the access limit of the camera.
[Default policy]
Select the basic policy of the limit from
[Allow] and [Deny] for the computers with
the network address that are not specified in
the [Network address/Subnet 1] to [Network
address/Subnet 10] menus below.
[Network address/Subnet 1] to [Network
address/Subnet 10]
Enter the network addresses and subnet
mask values that you want to allow or deny
access to the camera.
You can specify up to 10 network addresses
and subnet mask values.
Enter a value from 8 to 32 the subnet mask.
Select [Allow] or [Deny] from the drop-down
list on the right for each network address/
subnet mask.
Tip
The subnet mask value represents the
number of bits from the left side of the
network address.
For example, the subnet mask value for
"255.255.255.0" is 24.
If you set "192.168.0.0/24" and [Allow], you
can allow access from computers having an
IP address between "192.168.0.0" and
"192.168.0.255".
Note
You can access the camera even from a
computer with an IP address whose access
right is set to [Deny], if you enter the user
name and password set for the
Administrator in the User tab of the Security
menu in the authentication screen.
Setting the PTZF Control
— [PTZF control] Menu
PTZF control
When you click
Administrator menu, the [PTZF control] menu
appears.
The [PTZF control] menu consists of the [PTZF
control] and [Preset position] tabs.

[PTZF control] tab

Perform the pan/tilt/zoom/focus operation.
You can configure the settings from the OSD
menu. For details, see "ZOOM/FOCUS Menu
(SRG-XB25 only)" (page 31) or "ZOOM Menu
(SRG-XP1 only)" (page 32).
Note
You cannot configure Focus near limit, PTZ
mode, Pan-Tilt level, and Zoom level from the
OSD menu.
[Zoom]
[Zoom mode] (ZOOM - MODE)
Select the range of zooming.
[Optical]: An image can be zoomed up to
25x optical zoom. (SRG-XB25 only)
[Pixel]: Using pixel zoom, an image is
zoomed with little deterioration of
image quality over the optical region.
Zoom of up to 2x for 1080p video
format, and up to 3x for 720p video
format is supported. Not supported for
other resolutions.
[Digital]: On the SRG-XB25, an image can be
zoomed up to 25x optical zoom and 6x
digital zoom (including pixel zoom) for
a total of up to 150x zoom. The
SRG-XP1 does not have optical zoom,
only digital zoom (including pixel
zoom) for a total of up to 6x zoom.
Note
When [Video out] > [Resolution] is set to
3840×2160/59.94p or 50p and [Output
source] is set to [HDMI+Stream], operation is
not supported.
56
in the