Table of Contents
Advertisement
VANTAGE
®
II F
C
I
UEL
ONVERSION
NSTRUCTIONS
Tubes
Gas Line
Burner Observation
Window
Blower Scroll, Wheel and
Motor
Burner Cup and Orifice
Hot-Surface Igniter
Thermostat
Suspension Points
Decorative and Protective
Grilles (optional)
Lower Clearance Shield
(optional)
Wall Tag
Safety Labels
20 of 21
Make sure there are no cracks.
Make sure tubes are connected and suspended securely.
Make sure there is no sagging, bending or distortion.
Clean or replace as required.
Check for gas leaks.
Make sure it is clean and free of cracks or holes.
Clean and replace as required.
Compressed air or vacuum cleaner may be used to clear dust and dirt.
Clear of obstructions (even spider webs will cause problems).
Carefully remove any dust and debris from the burner.
Replace if cracked or broken.
There should be no exposed wire or damage to the thermostat.
Make sure the heater is hanging securely. Look for signs of wear on the chain
or ceiling.
The grille must be securely attached.
Check that side reflector extensions are installed correctly and secured in
place if necessary. (Decorative grille only.)
Make sure shield is installed correctly and secured in place if
necessary. (Decorative grille only.)
The lower shield must be securely attached. Inspect sheild support straps
and lower clearance shield anchor points.
Make sure shield is installed correctly and secured in place if necessary.
If wall tag is present, make sure it is legible and accurate. Please contact
Roberts-Gordon LLC or your ROBERTS GORDON
if you need a wall tag. See Page 4, Section 2.1.
Product safety signs or labels should be replaced by the product user when
they are no longer legible. Please contact Roberts-Gordon or your ROBERTS
independent distributor to obtain replacement signs or labels. See
GORDON
®
Page 2, Figure 1 through Page 3, Figure 2.
®
independent distributor,
Advertisement
Table of Contents
