Operating Tq-400 And Tq-800 Series; Powersave Mode With Indicator Light; Adjusting The Toast Feed Ramp - Hatco Toast Qwik TQ-10 Series Installation And Operating Manual

OPERATION

Operating TQ-400 and TQ-800 Series

1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
2. Move the Power I/O (on/off) switch in the I (on) position.
3. Adjust the Top Heat and/or Bottom Heat controls.
• For two sided toasting, turn the Top Heat control and
Bottom Heat control clockwise to the highest setting.
• For one sided toasting, turn the Top Heat control
clockwise to the highest setting and turn the Bottom
Heat control counter-clockwise to the lowest setting.
NOTE: When toasting a single-sided product such as a bun
or bagel, place the product with the cut side facing up.
Adjust the Bottom Heat Control to a light setting, toast
two slices of bread product and adjust the Top Heat
and/or Bottom Heat controls as needed.
4. Turn the Color Control to the lowest position ( ) while the
toaster heats up.
NOTE: Allow approximately 15 to 20 minutes for a warm-up
period.
5. After warm-up period, toast two slices of bread product.
Adjust the Color Control if needed.
NOTE: If toasted bread product is too dark with the Color
Control set on the lightest setting, adjust the Top and/
or Bottom Heat controls as needed. (Allow 15 to 20
minutes for toaster to re-adjust to new setting before
resuming operation.)
NOTE: To toast moist products such as English Muffins, rye
bread or whole wheat, slow the conveyor by turning the
Color Control knob to a darker setting (clockwise).
IMPORTANT NOTE
If the Warning light comes on, the unit may be overheating.
Turn off and unplug the unit. Refer to the "Daily Cleaning"
procedure to clean the cooling fan vents. If the unit does
not function properly after cleaning the cooling fan vents,
contact an Authorized Service Agent or Hatco for assistance.
Bottom Heat Control
Top Heat Control
Color Control
Control Panel – TQ-400 and TQ-800 Series

PowerSave Mode with Indicator Light

All TQ-400 and TQ-800 series toasters have a built-in
PowerSave Mode with Indicator Light feature. This feature
reduces power to the heating elements by 50 percent. During
PowerSave Mode, the indicator light on the
To activate PowerSave Mode:
1. Press the button until the indicator light flashes.
To exit PowerSave Mode:
1. Press the button or turn any knob until the indicator
light stops flashing.
NOTE: Allow a minimum of 5 minutes before toasting. Unit is
back up to full power within 10 minutes.
ColorGuard System
All TQ-400 and TQ-800 series toasters use a patented
ColorGuard Sensing System that monitors and automatically
adjust conveyor speed during high usage periods to assure
toast color uniformity.
NOTE: The ColorGuard Sensing System is inoperable for
approximately ten minutes after any heat adjustments
are made.

Adjusting the Toast Feed Ramp

The toast feed ramp is installed at the factory and can be used
in two positions.
Automatic Feed Position
For automatic feed, the toast feed ramp should be in an upright
position. Bread products enter the toaster by placing them on
the feed ramp and releasing.
Manual Feed Position
For manual feed, the toast feed ramp should be in a horizontal
position on top of the toaster. Bread products are manually
loaded by placing directly on the conveyor belt.
Automatic Feed
Position
Power Save Button
Warning Light
10
English
button will flash.
Manual Feed
Position
Toast Feed Ramp
Power I/O (on/off) Switch
Form No. TQ2M_CN-0519