Operation - Weed Eater 530087456 Operator's Manual

MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS 25 FT. 50 FT. 100 FT.
120 16 16 14
A.W.G.* A.W.G.* A.W.G.*
*American Wire Gauge
Secure extension cord to unit:
Tie the power plug on the unit to the
D
extension cord as shown.
Insert plug into cord socket.
D
Extension
Power Plug on
Unit
DOUBLE INSULATION CONSTRUCTION
This unit is Double Insulated to help
protect against electric shock. Double
insulation construction consists of two
separate "layers" of electrical insula-
tion instead of grounding.
Tools and appliances built with a
double insulation system are not in-
OPERATING INSTRUCTIONS
OPERATING POSITION
Your unit has two operating positions,
one for edging, one for beveling.
To set operating position:
S
Move pivot locking lever toward the
handle. Pivot motor to the desired
position. Release pivot locking lever,
making sure motor locks into position.
Pivot
Locking Lever
EDGING METHODS
WARNING:
The operator or others
must not try to clear away cut material
with the motor running or the blade
turning to avoid serious injury.
WARNING:
Stop motor and blade
and disconnect unit from power source
before removing materials wrapped
around blade shaft to avoid injury.
S
Allow the motor to reach full speed
before entering the material to be
tended to be grounded. No grounding
means is provided on this unit, nor
should a means of grounding be add-
150 FT. ed to this unit. As a result, the exten-
sion cord used with your unit can be
12
plugged into any standard 120 volt
A.W.G.*
electrical outlet.
Safety precautions must be observed
when operating any electrical tool. The
double insulation system only provides
added protection against injury result-
ing from an internal electrical insulation
failure.
WARNING:
Cord
this unit, including housing, switch,
motor, etc., must be diagnosed and re-
paired by qualified service personnel.
Replacement parts for a double insu-
lated appliance must be identical to the
parts they replace. A double insulated
appliance is marked with the words
DOUBLE INSULATION
. The symbol
LATED
square) may also be marked on the
appliance. Failure to have the unit re-
paired by an Authorized Service Deal-
er can cause the double insulation
construction to become ineffective and
result in serious injury.

OPERATION

cut. The blade has maximum cutting
power at full speed and is less likely
to bind or stall.
S
If blade does not turn when switch is
activated, make sure it is not stuck or
bound by debris.
S
Always release the switch and allow
motor to stop when not cutting.
S
To stop the motor, release the switch;
allow blade to stop turning before re-
moving it from the cut.
As you become familiar with your edger,
you will be able to determine your own
operating pace. Conditions such as
depth of cut, angle of cut, and material
being cut will regulate the speed and
time required for your edging job.
5
All electrical repairs to
or
DOUBLE INSU-
(square within a
Blade rotates mo-
mentarily after the
switch is released.
Stop rotating
blade by contact
with cut material.