Tube Assembly - Weed Eater 115253326 Instruction Manual

WARNING:
If received assembled,
review all assembly steps to ensure your unit
is properly assembled and all fasteners are
secure.

TUBE ASSEMBLY

Upper Locking Sleeve Assembly
Wire protector
Wires
Lower Locking Sleeve Assembly
1. Remove the wire protector from the
tubes and discard.
2. A lign upper tube groove with triangle on
lower locking sleeve assembly. Push
tubes together until they snap into place.
Upper Tube
Groove
Alignment Triangle
3. Try to pull tubes back apart. If the tubes do
not come apart, they are properly snapped
into place. If the tubes come apart, repeat
step 1 and push until the tubes snap into
place.
4. Slide upper locking sleeve assembly over
lower locking sleeve assembly and tight-
en by turning clockwise.
5. Ensure locking sleeve assembly and
alignment decals appear as illustrated be-
low.
Alignment decals
WARNING:
Failure to completely en-
close excess wires in upper tube during assem-
bly of the unit may result in damage to the wires
and/or the unit or serious injury to the operator
including electrocution.
ASSEMBLY
WARNING:
tubes must be snapped together, remain per-
manently assembled together and the locking
sleeve assembly must be fully tightened be-
fore and during use to avoid serious injury to
the operator and/or damage to the unit. DO
NOT attempt to disassemble unit after initial
assembly.
INSTALLATION OF ASSIST HANDLE
1. Place unit on a flat surface.
2. Remove knob and bolt from kit.
3. Firmly push the assist handle over the
tube. To make installation easier, tilt han-
dle toward trigger housing while pushing
down (see illustration).
4. Install bolt in handle. Thread knob
onto bolt.
5. Adjust the handle up or down the tube to a
comfortable postion; tighten knob secure-
ly.
Trigger
housing
ATTACHING THE SHIELD
WARNING:
erly installed. The shield provides partial
protection from the risk of thrown objects to
the operator and others. Your unit is equipped
with a line limiter blade, which cuts excess
line to the proper length while running. The
line limiter blade (on underside of shield) is
sharp and can cut you.
NOTE:
If shield is not properly installed, dam-
age to unit (including motor failure) will result.
1. Insert the shield onto the motor housing.
Ensure the cutting head remains free to
rotate and the line is not caught between
the shield and the motor housing (See
following illustration).
2. Twist the shield as illustrated until the
hole in the shield aligns with the hole in
the housings.
assembled to the unit as shown in the
illustration below and in the KNOW
YOUR UNIT section of this manual.
3. Install bolt into shield and motor hous-
ing as shown. Tighten securely.
4
The upper and lower
Assist handle
Tube
The shield must be prop-
Make sure the shield is