(Nautel Part # 195-2085, see Table 1) are 1.6 Special Tools/Test Equipment referenced in the following procedure. Standard hand tools (screwdriver, nutdriver, etc.) are required. Vector Series – NAPI80 Site Interface PWB Installation Procedure Page 1 IS09006A Issue 0.2...
Page 4
M3 split washers (HMW32) and pressing in on the black tabs in the eight M3 nuts (HMN02). center of the slide (see Figure 2). Vector Series – NAPI80 Site Interface PWB Installation Procedure Page 2 Issue 0.2 IS09006A...
ECMP, see the ECMP’s manual. (e) Using eight M3 screws (HMSP09F) install the site interface PWB on the pillars located on the rear of the front door. Vector Series – NAPI80 Site Interface PWB Installation Procedure Page 3 IS09006A Issue 0.2...