Advertisement
Quick Links
S c a n n e r S e t U p
S t r i n g S c a n I I
L i g h t w e i g h t Ma n u a l X - Y S c a n n e r
5 5 4 2 B u c k i n g h a m D r i v e
H u n t i n g t o n B e a c h C A , 9 2 6 4 9
P h o n e : 7 1 4 - 8 9 3 - 2 4 3 8 F a x : 7 1 4 - 8 9 7 - 3 8 4 0
E ma i l : I n f o @n d t s y s t e ms . c o m
w w w . n d t s y s t e ms . c o m
Advertisement
Summary of Contents for NDT StringScan II
- Page 1 S c a n n e r S e t U p S t r i n g S c a n I I L i g h t w e i g h t Ma n u a l X - Y S c a n n e r 5 5 4 2 B u c k i n g h a m D r i v e H u n t i n g t o n B e a c h C A , 9 2 6 4 9 P h o n e : 7 1 4 - 8 9 3 - 2 4 3 8 F a x : 7 1 4 - 8 9 7 - 3 8 4 0...
- Page 2 NDT Systems StringScan II Setup StringScan II component parts Remove the transducer holder from its ZERO park 1-Transducer Cable position and unscrew the two parts of the holder 1-SSxxx Transducer 1-Transducer Holder 1-Raptor Interface Cable 1-StringScan II Encoder Body Place the encoder rings over the inner holder piece Feed the transducer cable through the outer and inner pieces.
- Page 3 Connect the transducer and feed back into the housing Secure the transducer in the housing with the set screw insuring the transducer is flush with the housing front surface. Screw the housing halves together. Insure the encoder rings are free to rotate.
- Page 4 Place the transducer holder into its ZERO park position Zero park position Connect the transducer cable to the Raptor T/R port Connect the Raptor interface cable to the Scanner / Utility port...
- Page 5 Connect the scanner interface cable to the Select 5 SCAN on the Raptor and press ENTER StringScan II encoder body. Select 5 SCANNER on the Raptor and press ENTER Select SS2 – String Scanner 2 from the list and press ENTER...
- Page 6 Select 1 NEW Cscan and press ENTER Enter the X/Y lengths, index size, scan axis and test information, highlight ACCEPT and press ENTER. Place the transducer holder at the ZERO park ZERO park position Position and press ENTER...
-
Page 7: Start Scan
Place the transducer holder on the lower left corner Lower left corner position. Of the test piece and press ENTER Select 1 START SCAN and begin scanning test piece.