Special Notice - Weed Eater 530164008 Instruction Manual

Use only recommended Weed EaterŽparts;
D
use of any other parts may void your war-
ranty and cause damage to your unit.
Empty the fuel tank before storing the unit.
D
Use up fuel left in carburetor by starting the
engine and letting it run until it stops.
Do not use any accessory or attachment
D
other than those recommended by the
manufacturer for use with your unit.
Do not store the unit or fuel in a closed area
D
where fuel vapors can reach sparks or an
open flame from hot water heaters, electric
motors or switches, furnaces, etc.
Store in a dry area out of reach of children.
D

SPECIAL NOTICE:

For users on U.S. For-
est Land and in some states, including Cali-
fornia(Public Resources Codes 4442 and
4443), Idaho, Maine, Minnesota, New Jersey,
Oregon, and Washington: Certain internal
combustion engines operated on forest,
brush, and/or grass covered land in the above
areas are required to be equipped with a
spark arresting screen, maintained in effec-
tive working order, or the engine must be con-
structed, equipped, and maintained for the
prevention of fire. Check with your state or lo-
cal authorities for regulations pertaining to
NOTE:
It is normal for the fuel filter to rattle in
the empty fuel tank.
ASSEMBLY
WARNING:
If received assembled,
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure.
Follow all safety information in the manual
and on the unit.
No tools are required for assembly.
D
KNOW YOUR BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with locations of the various
controls and adjustments. Save this manual for future reference.
Blower Tube
these requirements. Failure to follow these
requirements is a violation of the law. This unit
is not factory equipped with a spark arresting
screen; however, a spark arresting screen is
available as an optional part. If a spark arrest-
ing screen is required in your area, contact an
authorized service dealer for the correct kit.
The spark arresting screen, blower tubes,
and nozzles must be assembled to unit to be
in full compliance with regulations.
SPECIAL NOTICE:
through prolonged use of gasoline powered
hand tools could cause blood vessel or nerve
damage in the fingers, hands, and joints of peo-
ple prone to circulation disorders or abnormal
swelling. Prolonged use in cold weather has
been linked to blood vessel damage in other-
wise healthy people. If symptoms occur such as
numbness, pain, loss of strength, change in skin
color or texture, or loss of feeling in the fingers,
hands, or joints, discontinue the use of this tool
and seek medical attention. An anti- vibration
system does not guarantee the avoidance of
these problems. Users who operate power tools
on a continual and regular basis must monitor
closely their physical condition and the condition
of this tool.
ASSEMBLY
BLOWER TUBE
Push the blower tube into the blower outlet
D
until it snaps into place.
Blower Outlet
Blower Tube
OPERATION
Primer Bulb
Throttle Lever
-- 3 --
Exposure to vibrations
Fuel Cap
Choke
Lever