Motorola Commercial Series Service Information page 33

1.0 Allocation of Schematics and Circuit Boards
1.1 UHF2 (438-470MHz)
The UHF circuits are contained on the printed circuit board (PCB) which also contains the Controller
circuits. This Chapter shows the schematics for the UHF circuits, the Controller circuits are
contained in Section 2 of this manual. The PCB component layouts and the Parts Lists in this
Chapter show both the Controller and UHF circuit components. The UHF schematics and the
related PCB and parts list are shown in the table below.
PCB :
SCHEMATICS
Parts List
1.2 Six Layer Circuit Board
The main PCB is a 6-layer circuit board, the copper steps are in the layer sequence shown below.
UHF2 PCB/SCHEMATICS/PARTS LISTS
Table 4-1 UHF2 Diagrams and Parts Lists
8486348Z13_C Main Board Top Side
8486348Z13_C Main Board Bottom Side
Radio Circuit Block Diagram
Receiver Front End
Receiver Back End
Synthesiser
VCO
Transmit and Power Control Cct
8486348Z13_C
SIDE 1
LAYER 1 (L1)
LAYER 2 (L2)
LAYER 3 (L3)
LAYER 4 (L4)
LAYER 5 (L5)
LAYER 6 (L6)
SIDE 2
Page 4-3
Page 4-4
Page 4-5
Page 4-6
Page 4-7
Page 4-8
Page 4-9
Page 4-10
Page 4-11
INNER LAYERS
Chapter 4