Making Ice - GE Profile OPAL Quick Start Manual

OPAL Ice Maker Quickstart Guide Continued
6. Now drain out the water by un-hooking the
tubes from the back of the Opal and placing
them in a sink or bucket. Remove the drain
plugs and allow all the water to drain out.
See Figure 5.
7. Replace the drain plugs and clip them back
onto Opal. See figures 6 and 7 for reference.
8. Add five cups of fresh water to the water
reservoir, and press the 'Clean' button to initiate
a second cleaning cycle. To exit the cleaning
cycle at any time, press and hold the 'Clean'
button for 3 seconds.
9. Repeat steps 4 through 8 two more times,
adding fresh water to the reservoir each time
(You may continue to repeat the rinse cycle, for
as many times as you like).
NOTE: It is recommended to clean/sanitize your
Opal ice maker per instructions in the Owner's
Manual, starting on page 7.

Making Ice

1. Fill the water reservoir to the upper fill line and replace the bin. Touch the Power button and Opal
will start the ice making process. The 'Making Ice' indicator on the left will light up as ice starts to
be made. You will see ice beginning to drop into the ice bin after about 20 minutes.
2. Opal will make about one pound of ice per hour. When the ice bin is full, the 'Making Ice' light will
no longer be illuminated. If Opal needs more water, the indicator on the left will illuminate 'Add
Water.'
2
Making Ice Add Water
Defrosting Cleaning
Figure 5
Figure 6
Replace drain tubes
Figure 7
Clean Lig
Hold 3 Sec
49-1000499 Rev. 2