Weber GENESIS GENESIS 1500 Owner's Manual page 23

Step 18
Install Lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place. Align the hinges at the rear of the
barbecue. Insert hinge pins from the outside. Insert hair pin
cotters into the small holes in the hinge pins. Figure 30.
Hair pin cotter
Hinge pin
Figure 30
Step 19
Add tool holders, control panel and burner
control knobs
You will need: three tool holders, control panel, two
Phillips screws/washers, a Phillips screwdriver, and three
burner control knobs.
Hook the tool holders over the frame rail and snap down
into place. Figure 31.
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Line up the holes in the control
panel with the holes in the inserts in the frame brace.
Insert screws and tighten with a Phillips screwdriver until
snug. Do not overtighten. Figure 31 (a).
Push on the burner control knobs. Figure 31 (b).
Crossover
Ignition Button
Tool holders
23
frame brace
(a)
Control panel
push-in buttons
(b)
Figure 31
Insert in