Korg Soundlink DRS OASYS PCI Installation Manual page 40

System Configurations
4.
5.
This connection is necessary when recording from the OASYS PCI's S/PDIF input.
6.
For details on setting the word clock source for a particular ADAT model, see the
ADAT's manual, or the OASYS PCI FAQ.
Below is a nifty little diagram, showing the OASYS PCI hooked up in a simple
system with two ADATs and a BRC. If you have more ADATs than shown here
(lucky you!), just pretend that this diagram's ADAT #2 is the last one in your
chain.
The OASYS PCI with 2 ADATs and a BRC
Word
Clock
BRC
36
Connect the optical output of the OASYS PCI to the optical input of ADAT
#1.
If using an Alesis BRC, connect the BRC's sync output to ADAT #1's sync
input, and then connect the Word Clock output of the OASYS PCI to the
48kHz Input of the BRC.
For general use, set the OASYS PCI's word clock source to ADAT, and the
ADAT system's word clock source to Internal.
Word Clock
Optical Sync
Optical Sync
Optical Sync
Installation and Setup
ADAT #1
ADAT #2
OASYS PCI
OASYS PCI