Advertisement
•PATTERN TOUR
MAIN MENU
LANGUAGE :ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
<CAMERA>
<MOTION>
RESTART
FACTORY DEFAULTS
EXIT
MOTION
<PRESET>
<SCAN>
<SEQUENCE>
<PATTERN>
<ZONES>
<TIMING ACTION>
<MOTION DETECT>
<AUTO TRACKING>
BACK
EXIT
PATTERN
PATTERN NO. :1
TITLE :PATTERN 1
START
<SET>
DELETE
BACK
EXIT
The dome supports 4 pattern tours and each pattern
cover at most 10 Minutes of 500 commands. Please check
the following steps to set up a pattern.
PATTERN NO.:
1)
Move the cursor here and click IRIS + to enter
the setup of Pattern Number. Click the up or down button to
select a pattern number (14) and click IRIS + to confirm.
TITLE:
2)
Move the cursor here and click IRIS + to enter the setup of
Pattern Title .Check the detailed above in DOME TITLE settings.
<SET>:
3)
Move the cursor here and click IRIS + to enter. Click the
dome up/down/left/right, make the zoom in/out and click IRIS +
to save the pattern tour.
START:
4)
Move the cursor here and click IRIS + to start the current
pattern tour.
DELETE:
5)
Move the cursor here and click IRIS + to delete the
current pattern tour.
- 58 -
OSD MENU
Advertisement
