Rear View Camera; Exceeding The Programmed Speed; Flashing Of Programmed Speed; Symbols And Messages On The Display - Fiat 500X Owner's Handbook Manual

when the Traffic Sign Recognition
system cannot display any speed limit.
EXCEEDING THE
PROGRAMMED SPEED
By fully depressing the accelerator
pedal, the programmed speed can be
exceeded even with the system active
(e.g. in the event of overtaking).
The system is disabled until the speed
drops below the set limit, after which it
activates again automatically.
FLASHING OF
PROGRAMMED SPEED
The programmed speed flashes in the
following cases:
when the accelerator pedal has been
fully depressed and the car has
exceeded the programmed speed;
activating the system after setting a
limit below the effective speed of the
car;
when the device cannot reduce the
speed of the vehicle due to the gradient
of the road;
in the event of sharp acceleration.

REAR VIEW CAMERA

DESCRIPTION
The camera A fig. 112 is located on the
tailgate.
133)
69)
112
Every time reverse is engaged, the
display fig. 113 shows the area around
the vehicle, as seen by the rear camera.
113
SYMBOLS AND
MESSAGES ON THE
DISPLAY
A superimposed central broken line
indicates the centre of the vehicle to
facilitate parking manoeuvres or tow
hook alignment. The various coloured
areas indicate the distance from the
rear of the vehicle.
F1B0064C
The table below shows the approximate
distances for each area fig. 113:
Area
Red (A)
Yellow (B)
Green (C)
IMPORTANT When parking, take the
utmost care over obstacles that may be
above or under the camera range.
F1B0167C
Distance from the
rear of the vehicle
0–30 cm
30–100 cm
1 m or more
143