Page 1
Swan ICE SHAVER INSTRUCTION MANUAL ELECTRIC TYPE SI-100E MODEL for Block Ice We sincerely want to thank you for purchasing our Swan brand ice shaving machine. For correct use of the product, be sure to carefully read the instruction manual. Furthermore, after reading it, the manual should be kept in your file so you can read it again in case of necessity.
Page 2
CAUTION Read the following instructions carefully before use. Do not fail to observe this. • Children or person who do not thoroughly understand the product should not be allowed to use it. • Use single phase 120V power source. • Place the machine on a strong and flat horizontal surface or location where dripping water is of no problem.
USING DIRECTION Use machine on a firm stand or counter. Replace or sharpen blade at least 2 or 3 times a season. Lubricate Main Shaft from time to time. Ice stored in refrigerator should not be sued immediately for shaving as it will damage the blad. Let the ice to thaw and become semi-transparent before use.
BLADE ADJUSTMENT The Blade is recessed below the surface of the Shaving Disc when the Blade Adjustment Dial is turned to 0. To raise the Blade, slowly turn the Blade Adjustment Know left. Set the Blade Adjustment Dial on 1 for fine shaving and 6 for roughest shaving. THE DIAL WILL INDICATE 0 WHEN THE BLADE ADJUSTMENT KNOW IS TURNED •...
REPLACEMENT BLADE Turn the Blade Adjustment Knob right all the way until it stops. Unscrew the two Phillips-screws. Remove the Blade Holder and blade. IMPORTANT: DO NOT MEDDLE WITH THE CENTER SLOTTED SCREW. Place the new Blade accurately on the Standard Level Guide Screws on the Blade Support. Put on the Phillips-screw and slowly screw it on so the blade will not life up from the Standard Level Guide Screws.
TROUBLE SHOOTING GUIDE PROBLEMS CAUSES SOLUTION Motor fails to turn. Cord Cord not properly plugged in Plug cord into socket properly Broker power cord Replace power cord Main Shaft do not Missing or broken Lock Pin Install new Lock Pin move up and down Block for Ice Block Holder Crank...
Page 7
SWAN ICE SHAVE NEW MODEL SI-100E (for Block Ice) PARTS No. PARTS NAME MATERIAL REMARKS Main Shaft Handle FC-20 Gear Box Cap FC-20 Worm Gear C5191-B Gear Box FC-20 Worm Gear Rubber Rubber Brake Adjustment Hole Plug Rubber Main Shaft...