Advertisement
Quick Links
5922 and 5932 SERIES
Handle Screw
Handle insert
(Not supplied)
Handle Hub
Escutcheon Gasket
1-7/8"
CAUTION:
Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer nuts are in place. The
cartridges and cartridge retainer nuts were properly installed and tested before leaving the factory. Although it is
unlikely, it is nevertheless possible that through the handling of the valve by any number of persons the cartridge
retainer nuts may not be properly installed. This should be carefully checked at time of rough-in and trim-out. If the
cartridge retainer nuts are not properly installed, water pressure could force the cartridge out of the casting. Personal
injury or water damage to the premises could result.
®
LEVER HANDLE
TWO-HANDLE LAVATORY
FAUCET
FLOW-RATOR
AERATOR
SPOUT
4" Centers
Cold
Hot
6-3/4" x 2-3/8" Wide
Complies with ASME A112.18.1M and CSA B125
Always turn water off before disassembling the valve. Open valve handle to alleviate
water pressure to insure that complete water shut-off has been accomplished.
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
15/16" MAX.
Mounting
nut/washer
Tailpiece
nut
Supply
(Not Furnished)
MT125A
LEFT WITH HOMEOWNER
High Arc Spout Model
Tea Kettle Spout Model
Advertisement
Related Manuals for Moen 5922 Series
Summary of Contents for Moen 5922 Series
- Page 1 5922 and 5932 SERIES MT125A ® INSTALLATION INSTRUCTIONS THESE INSTRUCTIONS MUST BE LEFT WITH HOMEOWNER LEVER HANDLE TWO-HANDLE LAVATORY FAUCET FLOW-RATOR AERATOR SPOUT Handle Screw Handle insert (Not supplied) Handle Hub High Arc Spout Model Escutcheon Gasket 15/16" MAX. 1-7/8" 4"...
- Page 2 Handle Insert Installation Plug Button 1. Be sure O-ring is in place on insert as shown. Handle 2. Screw insert into handle hub. Handle Hub Insert Faucet Installation 1. Be sure basin is clean and dry. Place a 3/8" bead of plumber's putty (not supplied) on underside of deck gasket.
- Page 3 Reassembly CAUTION: Failure to follow these instructions can cause personal injury or water damage to the premises, or could result in a faulty Stem installation or damage the new cartridge. 1. Rotate the cartridge stem so hole in piston lines up with hole in the cartridge shell as shown at right.
- Page 4 Toronto, 905-829-3400 Rest of Canada, 1-800-465-6130 ® ® © Copyright 1995 Moen Incorporated 25300 Al Moen Drive, North Olmsted, OH 44070-8022, U.S.A. Moen Incorporated In Canada: Moen Inc. 2816 Bristol Circle, Oakville, Ontario L6H5S7 MT125A SEP 95 Printed in U.S.A.