Advertisement
6. Slide the blower into position, making sure the blower base inserts into the grommets, locking it in place.
Secure all loose wiring by inserting it through the cable holder installed earlier.
7. Plug the blower in and verify operation. The blower will turn on after the insert reaches temperature,
typically 5 to 10 minutes after startup on high.
Operating Instructions
The blower will turn on automatically once the insert is up to temperature (5 to 15 minutes).
Blower speed can only be altered with the face removed. The face should remain in place during operation.
Therefore, we recommend you set the blower at a middle position, install the face, then turn the insert on. If
the blower speed is not at the desired level, let the insert cool, remove the face, adjust the blower rheostat,
then re-start the insert.
Service Instructions
WARNING:
Disconnect power to the blower before servicing (unplug power cord or turn off service breaker).
The blower assembly may be removed while leaving the wires connected. Slide the blower forward off of
the grommets, being careful to not damage or disconnect any wiring (see illustration above). The blower
may be vacuumed or brushed clean. Re-install the blower after cleaning, making sure the blower base
inserts into the grommets. Make sure all wiring remains connected and does not contact any hot or moving
components.
Page 4 of 4
Radiant (Small or Large) Blower
Installation Instructions
17601904 - 1/21/16
(sku 99000192)
© Travis Industries, Inc.
Advertisement
