Appendix B Standard Compliance - Zte ZXDSL 831A II User Manual

Hide thumbs

Table Of Contents

Table of Contents

The equipment complies with the following ADSL standards:

ANSI T1.413 Issue 2

ITU G.992.1 Annex A

ITU G.992.2 Annex A

ITU G.992.3 Annex A

ITU G.992.3 Annex L

ITU G.992.5 Annex A

ITU G.994.1

ZTE's equipment complies with the following national standards of the PRC:

Standard No.

GB 4943-2001

GB 9254-1998

GB/T 17618-1998

GB 17625.1-2003

GB 17625.2-1999

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired

operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.