Plustek NVR X840P User Manual page 30

Add a new IP Camera manually
1. Go to the "Setup" page and click on "Camera", "Channel" tab.
2. Select a "Vendor" from the drop-down list. Enter the IP Camera's "Name" that will
be used throughout the menus and the user interface of the NVR Viewer, the
"Device Name", "IP Address", "WEB Port" "User Name" and "Password". Enter the
password again in "Confirm Password". Activate the "Enable default motion
recording" checkbox if desired.
3. Click the "Add" button to add the IP Camera to the channel list. The IP Camera's
connection, recording and alarm status will be shown.
Add a new general IP Camera manually
This method is intended for power users as it requires knowledge of
the IP camera's RTSP URLs. Contact your IP camera's manufacturer
for the correct URLs to enter.
Information
If you have an IP camera of an unsupported vendor you can follow below instructions
to add it to the NVR.
1. Go to the "Setup" page and click on "Camera", "Channel" tab.
26