Hook-Up Guide; Wall Mounting Instructions - Monster Power GreenPower PowerCenter HDP 850G Instructions And Warranty Information

HOOK-UP GUIDE
Attach a Monster Power identification label to each
component's power cord before you plug it into the
appropriate color-coded PowerCenter outlet.
Plug each component's power cord (HDTV,
AV receiver, Cable/Satellite box, etc.) into the
PowerCenter's corresponding outlet.
NOTE: The outlets on your PowerCenter are labeled for your convenience. It will not
harm your equipment to plug into an outlet that's labeled differently.
To ensure against the possibility of data loss or corruption, you should connect
hard drive-based devices to unswitched outlets or disable GreenPower using
the switch located on the end of the PowerCenter.
Monster assumes no responsibility for data loss, corruption or damage to hard
drive-based devices connected to PowerCenters with GreenPower automatic
outlet switching.
COAXIAL CONNECTIONS HOOK-UP
CONNECTING TO GREENPOWER- OUTLETS
Coaxial Connections provide surge protection against damaging
voltage surges and spikes on the incoming cable TV and satellite lines.
NOTE:
Ifyou don't want any outlets to automatically switch off,
Monster GreenPower can be disabled by the switch located
on the end ofthe PowerCenter.
WARNING:
Important data and settings stored on hard drives (recorded TV shows,
game saves, etc.) may be corrupted or deleted if power is turned off while the
hard drive is being read from or written to.
To
. . . TY/ClIIIle
I .
WALL-MOUNTING INSTRUCTIONS
The PowerCenter comes with keyholes for convenient wall-mounting.
1. Select the best location to mount the PowerCenter and mark
the position for the four mounting screws (screws not supplied).
2. Drive pan-head screws with spacer eyelets into the wall (use drywall anchors
for hollow walls) at the locations you marked, leaving the eyelet exposed.
3.
Position the key-holes on the back of the unit over the screw/eyelets
and slide the PowerCenter down until it locks into position.
• I :
1. Connect your AV Receiver or
HDTV to the "GREEN POWER
CONTROL' outlet.
2. Connect devices such as Plasma
TV, Subwoofer, and DVD/Blu-ray
Disc™ Player to "GREEN POWER
CONTROLLED" switched outlets
so they won't use power when
the component connected to the "GREENPOWER CONTROL'
outlet is powered off or in sleep mode.
If you hook up a hard drive-based device such as a TiVo@, DVR or video game
console to a "GREENPOWER CONTROLLED" switched make sure the device is
NOT being read from or written to when you turn off the equipment connected
to the "GREENPOWER CONTROL' outlet.