Bosch WAW285H2UC Use And Care Manual / Installation Instructions page 42

Determing the Problem
Problem
Washer door cannot be
opened.
Door still cannot be
opened, even after
turning the washer off
and back on again.
Wash cycle time is
increased.
Washer does not start.
Start/Pause indicator
light does not flash.
The display panel and
indicator lights switch
off, Start/Pause indica-
tor flashes.
The display panel and
Start/Pause indicator
switch off.
Cycle does not start -
Start/Pause flashes.
Cycle does not start -
Finish in-time is dis-
played.
Cycle does not start -
symbol flashes.
D
Detergent residue
remains in the deter-
gent dispenser.
42
Possible cause(s)
Child lock is activated.
A power failure occurred.
Cycle is running, or water level is
too high and/or too hot or the drum
is still spinning.
Electric power cord has become
loose or unplugged.
Appliance switched off before end
of cycle.
Child lock is activated.
Door is locked for safety reasons
(high water level, water temperature
too high, drum is spinning).
Your washer utilizes sensors to
monitor certain characteristics of
the wash load. Increases in wash
cycle time could be due to:
The automatic unbalanced load
detection system spins the laundry
several times to ensure even distri-
bution.
Excess suds. displays at end of
Å
cycle.
Power cord end not inserted or not
inserted correctly.
A fuse is blown or breaker is
tripped.
Door not closed properly.
Energy-saving mode is activated.
Automatic switch-off function is
active.
Start/Pause button not pressed.
A delayed starting time has been
selected and activated.
Child lock is activated.
Dry detergent may have been damp
or lumpy.
Excess liquid detergent may have
been added.
Solution(s)
Deactivate Child lock (press Finish in
approximately 3 seconds).
If a cycle is interrupted by a power failure, it will resume
when the power is restored. If power is not restored fol-
low the cautions and instructions for Emergency door
lock release:
~ Emergency door lock release; Page 41
Wait until the cycle ends.
Make sure the electric cord is securely plugged in.
Switch the appliance on.
Deactivate Child lock (press Finish in
approximately 3 seconds).
Run a Spin/Drain program to reduce the water tem-
perature and level.
Solutions are based on the specific reason the wash
time has been extended.
Always load the washer with a mixture of large and
small wash items (easier to distribute in the drum).
Use less detergent.
Insert power cord end correctly.
Replace fuse or reset breaker. For replacing the fuses
in the supplied Power Adapter refer to the instructions
which came with the Power Adapter.
Check if laundry is caught in the door. Close the door
until you hear it click shut completely.
Press any button to activate the display.
Press the center of the Program Selector to switch on
the appliance.
Press the Start/Pause button to start the cycle.
Wash cycle will begin at proper time to complete at the
selected Finish in-time.
Deactivate Child lock (press Finish in
approximately 3 seconds).
Clean and dry the detergent dispenser.
See Adding the correct amount of HE detergent to
determine proper detergent usage. ~ Adding the cor-
rect amount of HE detergent; Page 33
and for
M N
and for
M N
and for
M N