Using The Projector; Turning The Audio/Visual(A/V) Equipment On And Off; Turning The Projector On And Off - Vivitar DP-1200 X User Manual

Projector
User's Manual

Using the Projector

This section describes projector operations:
Turning the projector and A/V equipment on and off
Adjusting the projected image
Projector controls
Checking the projector status
Turning the Audio/Visual (A/V) Equipment On and
Off
Always turn on the projector and related A/V equipment in the following order.
1.Projector
2.Computer
3.Video source
4.Audio source

Turning the Projector On and Off

1.Connect the power cord to the projector.
2.Insert the power plug into a wall outlet.
3.Remove the projector lens cap.
4.Press the Power button (on either the Remote Controller or the Projector Control
Panel) to turn on the projector. When the lamp LED indicator lights in green, the
projecting image gets full illumination.
Warning:
Never look into the lens when the lamp is on. This can damage your eyes.
It is especially important that children are not allowed to look into the lens.
5.To turn off the projector, press the Power button. A message will appear on the
screen for about 10 seconds:
6.Press the Power button once again(to turn off the power) while the message is still
showing on the screen.
Note:
Please wait until the fan motor turns off and the Power LED becomes red before
removing the power cord from the projector.
EN-14