Turning Your Inverter On And Off; Cobra Remote On/Off Controller With Fast Charge Usb - Cobra POWER 500W Owner's Manual

TURNING YOUR POWER INVERTER ON AND OFF
Be sure to have your power inverter properly installed before attempting to turn the unit on
(see installation beginning on page 10)
To turn the power inverter on:
1. If a DC power supply is being used as the power source, switch it on.
2. On the Output End, press the Power Button to on.
NOTE: The Power Button turns the control circuit in the inverter on and off. It does not disconnect
power from the inverter.
When the button is in the off position, the inverter draws no current from the battery. When it's in
the on position, but no power is being supplied to a load, the inverter draws less than 600
milliamperes from the battery. This is low current draw. It would take more than a week to discharge
a 100 ampere-hour battery at this rate depending on the age of the battery.
COBRA REMOTE ON/OFF CONTROLLER WITH
FAST CHARGE USB
Your Cobra POWER inverter is equipped with an RJ-45 jack labeled "REMOTE" for compatibility with the
Cobra Remote On/Off Controller with Fast Charge USB* to allow you to conveniently turn the inverter
ON and OFF from anywhere inside your vehicle as well fast charge your devices at the same time. Perfect
for use while driving, traveling, camping or tailgating when your inverter is out of reach. (4) mounting
options allow you to install it permanently, use it while driving in a cup holder or clip it to the back of a
seat or a place inside your vehicle.
*Sold Separately. Can be purchased on www.Cobra.com
15 | P a g e
The power inverter is now ready to deliver AC power to your loads. If
several loads are to be operated by the inverter, turn them on
separately, after the inverter has been turned on. This will ensure that
the inverter does not have to deliver the starting currents required for all
the loads at once.