LG CRN-8240E Owner's Manual page 19

I Windows NT Installation
Use the selection path:
Control Panel->SCSI Adaptor->Drivers
Click on Add, put the supplied disk in drive A:, then click on Have Disk and OK. Click
on the LG Electronics PCMCIA ATA/ATAPI Adaptor. After installation, you will be
asked to reboot. After rebooting the system, the new drive icon will show up.
Notes:
• The Windows NT operating system does not support the Hot-Swap feature. The
card and the CD-ROM drive need to be setup correctly before booting up Windows
NT. Do not un-plug the card or CD-ROM drive while the system is still running. Turn
off the CD-ROM drive and the computer before removing the PCMCIA card.
• When using Windows NT, the CD-ROM drive through PCMCIA interface may not be
recognized in some computers.
E-19