Maintenance - Poulan Pro PPB40T Instruction Manual

CHARGING PROCEDURE
1. Plug the charger into an AC power
outlet.
2. Insert the battery pack (1) into the
charger (2).
3. This is a diagnostic charger. The
Charger LED Lights (3) will illuminate
in specific order to communicate the
current battery status. They are as
follow:
2
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
FULLY CHARGED:
BATTERY IS TOO WARM OR TOO COLD:
(REMOVE FOR APPROX. 30
MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT
DEFECTIVE BATTERY:
(REMOVE AND REPLACE WITH
NEW BATTERY IF THIS OCCURS)
CHECKING BATTERY CAPACITY
Press the Battery Capacity Indicator (BCI)
button. The lights will illuminate according to
the battery's current power level. See chart
below:
BCI
BUTTON

MAINTENANCE

CHARGER MAINTENANCE
•
•
•
1
•
BATTERY PACK
•
•
•
3
CUTTING LINE
RED RED
•
GREEN
RED
RED
ORANGE
•
OFF
RED
RED
RED
BLINKING
CLEANING
1.
2.
3.
LIGHT
METRE
BATTERY
METRE
CAUTION: Do not use strong solvents or
detergents on the plastic housing or plastic
components. Certain household cleaners
may cause damage and may also cause a
shock hazard.
12
Keep the charger clean and clear of debris.
Do not allow foreign material to get into the
recessed cavity or onto the contacts. Wipe
the charger clean with a dry cloth. Do not
use solvents or water, and do not place the
charger in wet conditions.
Unplug the charger when there is no
battery pack in it.
Fully charge the batteries before placing
them in storage.
Store the charger at normal room
temperature. Do not store it in excessive
heat. Do not use the charger in direct
sunlight. Recharge at temperatures
between 32°F and 104°F (0-40°C). If
battery pack is hot, allow it to cool down
before recharging.
Store the battery pack fully charged.
Once the charging light turns green,
remove the battery from the charger and
disconnect the charger from the outlet.
After charging, the battery pack may be
stored on the charger, as long as the
charger is not plugged in.
Use only .080" (2mm) diameter cutting
line. Other sizes will not advance properly
and could result in failure, or cause serious
injury.
Always wind the line in the same direction
as the arrow on the spool.
Wipe the outside of the string trimmer
with a dry, soft cloth. Do not hose down
or wash with water.
Scrape the guard and spool area to
remove dried clippings and mud.
Brush or blow dust, debris, and grass
clippings out of the air vents. Keep them
free of obstruction.