Function Buttons; Cooler Location - Honeywell DCS2AE User Manual

USE & OPERATION (CONTINUED)

FUNCTION BUTTONS

FAN SPEED SELECTION
Press until desired speed lights up.
Sleep mode is for energy-saving comfort
during the night. When activated, the fan
speed will run on current or medium speed
for 30 minutes and gradually reduce to Low
speed until the unit is manually switched
OFF.
2.0A USB CHARGE PORT
Plug in to power or charge USB devices like
your smartphone or tablet.
IMPORTANT: Different devices draw different
amounts of power. Devices such as tablets
may require more power and longer charging
times for a full recharge.

COOLER LOCATION

Position the ZETA™ Air Cooler on a flat and stable surface.
Open a window or door for adequate cross-ventilation in Cooling Mode. The maximum cooling effect is felt when a
person is near the flow of air coming out of the Cooler.
The ZETA™ produces moisture and can be used to humidify dry air. To be used for humidification windows and
doors should be closed.
IMPORTANT: The evaporative air cooler is not an air conditioner as it does not use a compressor or refrigerant gas.
It should not be expected to cool as efficiently as a refrigerated air conditioner.
POWER ON/OFF
When ON, the cooler will start at medium
speed and reduce to low speed after a few
seconds. Press again to turn Off.
COOLING MODE
Turns On/Off evaporative cooling. When
light is ON, the water pump turns on and
evaporative cooling is activated. You will feel
the cooler air after the Honeycomb Cooling
Media is completely wet. When light is OFF,
the unit functions as a normal fan without
evaporative cooling.
HUMIDIFICATION
You can use the unit as a Humidifier by
keeping Cooling Mode on and windows/doors
closed to collect moisture in a dry room.
EN 4