Sony DVP-M35 Operation Manual page 60

r
Pin Signal Name I/O
71
69
72 H C W H L B S
6 3 - 5 7
56
14
I / O
G I O l/INT3 I / O
13
12
11
10
9
5-1,
00-98
88 TTREF
89 TRIN
I TTL
o / z CMOS
I TTL
I / O TTL
TTL
General input/output pin
TTL
TTL
TTL
TTL
TTL
TTL
TTL
Track counter
I TTL
(Hysteresis)
I TTL
(Hysteresis)
Function
Frame sync signal/host data write strobe signal input
for data transmission. In the serial mode, the data
transmission frame sync signal is input. In the parallel
mode, the data write strobe signal is input.
Host serial data/host interrupt signal output. In the
serial mode, the serial data is output. In the parallel
mode, the host interrupt signal is output.
Clock/host low byte select signal input for host serial
data'transmission. In the serial mode, the serial data
transmission clock is input. In the parallel mode, the
low byte select signal is input.
General data output/parallel data input/output. In the
serial mode, the general data is output. In the parallel
mode, the parallel data is input/output.
General data/parallel data input/output. In the serial
mode, the general data is input/output. In the parallel
mode, the low byte select signal is input.
General data inputioutputANT2 external interrupt
signal input. Selected by the interrupt control register.
General data input/output/INT3 external interrupt
signal input. Selected by the interrupt control register.
General data input/output/INT4 external interrupt
signal input. Selected by the interrupt control register.
General data input/output/INTS external interrupt
signal input. Selected by the interrupt control register.
General data input/output/timer 0 external clock
input. Selected by the timer control register.
General data input/output/timer 1 external clock
input. Selected by the timer control register.
General data input/output. The input/output is set by
the GIO control register. The input data is set to the
general input register. The data of the general output
register is output. When using a GIO from GIOO to
G105 as the interrupt signal or input clock, be careful
not to set the corresponding control bit to the output
when changing the value of the GIO control register
value.
Track counter reference pulse signal input.
Track pulse signal input.
1