Summary of Contents for Honeywell GENT Mimic LED Driver Card
Page 1
Data and Installation Mimic LED Driver Card by Honeywell S4-34600 & S4-34494 S4-34600 S4-34494 Mimic LED Driver Card Connection Converter 26-way 300mm ribbon cable 20-way 200mm Flat flexible cable These instructions cover the Mimic LED Driver LED selection Card (S4-34600) and Connection converter...
Page 2
Data and Installation Mimic LED Driver Card Mounting It is recommended that the Mimic LED Driver Cards are mounted inside a Custom panel using suitable PCB standoffs, there are 6-3mm PCB fixing holes provided on the card. The Connection converters are mounted on 35mm DIN rails.
Page 3
Mimic LED Driver Card Data and Installation To connect multiple Mimic LED Driver Cards You can daisy chain up to two Mimic LED driver cards to the Master Repeat Card using the 20 way flat flexible cable Mimic LED Driver Mimic LED Driver Master Repeat Card Card 2...
Do not burn. Gent by Honeywell reserves the right to revise this publication from time to time and make changes to the content hereof without obligation to notify any person of such revisions of changes.
Page 5
Commissioning information Mimic LED Driver Card by Honeywell S4-34600 & S4-34494 The illumination of LEDs connected to the Connection Converters of a Mimic LED Driver Card is determined by the configuration held at the Master Repeat Card (MRC). The following information show how to load a LED Driver template file and associate LED shapes with terminals of Connection converter and configure each LED shape with a system event using the Mimic Configuration tool.
Test the Custom panel and ensure it gives the correct indication for the configured Vigilon System event. Gent by Honeywell reserves the right to revise this publication from time to time and make changes to the content hereof without obligation to notify any person of such revisions of changes.