Advertisement
THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL
SAFETY AND/OR PROPERTY OF YOURSELF AND OTHERS. READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL BEFORE
INSTALLING THE LIGHT KIT. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. WHEN YOU SEE
THIS SYMBOL—
HEED ITS WARNING.
Your log splitter was built to be operated and towed according to the rules for safe operation in this
manual. As with any type of power equipment, carelessness or error on the part of the operator can result
in serious injury. If you violate any of these rules, you may cause serious injury to yourself or others.
TOWING
1. This unit should not be towed on any street, highway or public
road without checking the existing federal, local or state
requirements. Such information may be obtained by calling
your state or local bureau of motor vehicles. Any licensing or
modifications needed to comply with federal, local or state
vehicle requirements is the sole responsibility of the
purchaser.*
2. Before plugging log splitter lights into tow vehicle, make sure
the tow vehicle is wired the same as the log splitter (e.g. ground
to ground, left turn to left turn, etc.). Refer to Figure 9 in this
Owner's Guide. Failure to wire unit correctly may cause the tow
vehicle wiring to overheat and/or the log splitter lights to
operate incorrectly. It may be necessary to replace the turn
signal flasher unit in your tow vehicle if it is not capable of oper-
ating the additional lights on the log splitter.
3. Before towing the log splitter on a street, highway or public
road, verify that all lights are functioning properly and the
yellow side reflectors are in position. Replace bulbs if they are
burnt out.
4. Before towing, always check to be certain the log splitter is
correctly and securely attached to the tow vehicle, and safety
chains are in place. Leave slack in chains for turning allowance.
5. Use a class I or higher hitch with a 1-7/8" ball. Keep ball socket
and clamp face lubricated with chassis grease.
6. Be sure the coupler is secured to the hitch ball and the lock
lever is down tight and locked.
7. Check vehicle hitch, ball and coupler for signs of wear or dam-
age. Replace any parts that are worn or damaged before towing.
8. The coupler must be secured to the log splitter tongue tube with
the original equipment bolts and nuts. See your authorized
service dealer for replacement parts. Coupler nuts should be
tightened securely (20 foot pounds).
9. Make sure beam assembly is securely latched in the horizontal
position and jack stand (if provided) is pivoted and secured in
the up position before towing log splitter. Never tow with the
beam in vertical position.
10. Do not tow the log splitter faster than 45 MPH. Higher speeds
may damage log splitter. Excessive high speeds may cause the
log splitter to "fishtail" or otherwise become unstable.
IMPORTANT
RULES FOR SAFE OPERATION
DANGER
11. Check the tire pressure on the log splitter tires. It must be 15
p.s.i. for highway travel.
12. When parking, storing or using your log splitter, keep the
coupler off the ground so dirt will not build up in the ball socket.
13. Do not allow anyone to sit or ride on your log splitter. They can
easily fall off and be seriously injured.
TRAINING
1. Before operating this splitter, read and understand this manual
completely. Become familiar with it for your own safety. To fail
to do so may cause serious injury. Do not allow anyone to
operate your splitter who has not read this manual. Keep this
manual in a safe place for future and regular reference and for
ordering replacement parts.
2. Never use your splitter for any other purpose than splitting
wood. It is designed for this use and any other use may cause
an injury. Your log splitter is a precision piece of power equip-
ment, not a toy. Therefore, exercise extreme caution at all times.
3. Never allow children to operate your log splitter. Do not allow
adults to operate it without proper instruction. Only persons
well acquainted with these rules of safe operation should be
allowed to use your log splitter.
4. Only the operator is to be near your log splitter during use. Keep
all others, including pets and children, a minimum of 20 feet
away from your work zone. Flying wood can be hazardous. If a
helper is assisting in loading logs, never activate the control
until the helper is clear of the area. More accidents occur when
more than one person operates the log splitter than at any other
time.
5. No one should operate this unit while intoxicated or while taking
medication that impairs the senses or reactions. A clear mind is
essential for safety. Never allow a person who is tired or other-
wise not alert to use your splitter.
PREPARATION
1. Never wear loose clothing or jewelry that can be caught by
moving parts of your log splitter and pull you into it. Keep
clothing away from all moving parts of your log splitter.
* If a "Statement of Origin" is required in your state, telephone
1-800-800-7310 and request one from MTD/YardMan Customer
Assistance.
2
Advertisement
