Download Print this page
Vermont Castings DVA4136 Installation Instructions
Vermont Castings DVA4136 Installation Instructions

Vermont Castings DVA4136 Installation Instructions

Vermont castings brick works ceramic refractory installation instructions 33xdv, 36xdv, 39xdv, dv360, dva4136, dvb4136

Advertisement

Ceramic Refractory

Installation Instructions

for use on Models:
33XDV, 36XDV, 39XDV,
DV360, DVA4136, DVB4136
Finish colors available: Sandstone, Colonial Red, Clas-
sic Black, Silver Gray. Country gray is available for the
DVA4136 and DVB4136 only.
Read these instructions before attempting to install
the panels.
CAUTION: Before starting installation of
the CR Kit allow unit to cool completely if
it has been in operation.
Ceramic refractory panels are fragile until
held in place and supported. Handle with
care to avoid damaging or breaking.
Kit contents:
Left Side Panel (1)
Right Side Panel (1)
Rear Panel (1)
Installation Instruction Sheet (not shown) (1)
Installation Instructions
Turn OFF gas and electrical supply to unit before
starting the CR kit installation.
1. Check all contents for damage or missing parts.
2. When the unit is cool, remove top louvre. (Refer to
Homeowner's Manual)
3. Open bottom louvre.
4. Remove the glass frame window. (Refer to Home-
owner's Manual)
Fig. 1 Ceramic Refractory Kit contents.
5. Make sure logs are not hot and remove them. Logs
6. Remove all the lava rock from the firebox floor.
7. Remove the deflector inside the firebox just behind
8. Place the rear panel over the ledge of the rear
9. Place one of the side panels into place. It will hold
10. Place the other side panel into place.
11. Reinstall the deflector using the saved screws.
12. Re-install the lava rock. (Refer to Homeowner's
13. Reinstall the logs. (Refer to Homeowner's Manual)
14. Reinstall the glass frame window and close the
15. Installation is complete.
16. Attach the top louvre (Refer to Homeowner's
CFM Corporation
410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6
800-668-5323 • www.cfmcorp.com
Left Side Panel
Rear Panel
are fragile and easy to break. Handle with care.
Save for later.
the glass. Save the screws.
log support bracket. You may need to loosen the
�����
screws securing the bracket. Re-tighten the screws
������� ������� ������
after placing the ceramic panel in place.
����
the rear panel secure.
Manual)
clamps.
Manual), turn ON the gas supply and electrical sup-
ply, light the unit and close the bottom louvre.
Right Side Panel
KT605
10009406 6/07 Rev. 2

Advertisement

loading

This manual is also suitable for:

Dvb4136