Advertisement
Important Safety Information
Transport Machinery Safely
Maximum transport speed for the implement on its own
tires is 20 mph (30 kph). Rough terrain may require a
slower speed. Sudden braking can cause a towed load to
swerve and upset.
Do not exceed 20 mph (30 kph). Travel only at a speed
which allows adequate control of steering and stopping.
Comply with state and local laws.
Carry reflectors or flags to mark drill in case of
breakdown on the road.
3-point implements reduce weight on steering tires. Verify
that tractor is correctly ballasted. Watch for signs of poor
steering traction.
Shutdown and Storage
Park on level ground.
Unhitch and store the drill in an area where children
normally do not play.
Tire Safety
Tire changing can be dangerous and should be
performed by trained personnel using correct tools and
equipment.
When inflating tires, use a clip-on chuck and extension
hose long enough for you to stand to one side–not in front
of or over tire assembly. Use a safety cage if available.
When removing and installing wheels, use wheel-handling
equipment adequate for weight involved.
Practice Safe Maintenance
Understand procedure before doing work. Use proper
tools and equipment. Refer to this manual.
Work in a clean, dry area.
Lower the drill, put tractor in park, turn off engine, and
remove key before performing maintenance. If work must
be performed with implement raised, use blocks or
jackstands rated for the drill weight.
Make sure all moving parts have stopped and all system
pressure is relieved.
Allow drill to cool completely.
Disconnect lighting connector before servicing or
adjusting electrical systems.
Welding: Disconnect battery ground. Avoid fumes from
heated paint.
Inspect all parts. Make sure parts are in good condition
and installed properly.
Remove buildup of grease, oil or debris.
Remove all tools and unused parts from drill before
operation.
2018-06-12
Table of Contents
3P500, 3P500V, & 3P600
313-517M
3
Advertisement
