Advertisement
Quick Links
Advertisement
Related Manuals for Biostar DCS3A
Summary of Contents for Biostar DCS3A
- Page 1 DCS3A Manual...
- Page 2 DCS3A Manual Table of Contents Preface ....................3 Chapter 1: Introduction.................4 Chapter2: Hardware Installation ............5 Chapter3: Driver Installation..............6...
-
Page 3: Preface
DCS3A Manual Preface Disclaimer Information in this document has been carefully checked; however, no guarantee is given to the correctness of the contents. No responsibility is assumed for its use or for any infringement of patents or rights of third parties that may result from its use. No license is granted by implication or otherwise under the patent rights. -
Page 4: Chapter 1: Introduction
Support AHCI / NCQ Interface PCI-E2.0 x1 Type SATA3 6Gbps / SATA2 3Gbps/ SATA 1.5Gbps 1.2 System Requirements The following operating systems are supported: • Windows XP • Windows Vista • Windows 7 1.3 DCS3A Layout LED1 SATA_CO NN2 SATA_CO NN1... -
Page 5: Chapter2: Hardware Installation
Please follow the steps below to install your DCS3A card: Shut down the computer and remove the case cover. Remove the blanking plate from the PCI-Express. Press DCS3A card firmly into the PCI-Express slot, making sure it is properly seated. Secure the card in place with a screw. -
Page 6: Chapter3: Driver Installation
DCS3A Manual Chapter3: Driver Installation The screenshots in this manual are for reference only. Note: Please follow the instructions in this section to install the driver for your DCS3A card. Insert the Setup CD into the optical drive in your system. The program should automatically display the screen. - Page 7 DCS3A Manual Note: When installing Windows XP on the HDD connected to DCS3A card, you need a floppy drive in your system. As to the driver files, you may use other computer to launch installation program firstly, and click on F6 floppy Asmedia 106x SATA Host Controller Drive to copy the files to your floppy disk.