Veo Infra-Red User Manual page 21

Network Camera User's Guide
3 Preset /
Recall mode
4 Preset /
Recall camera
locations
5 Camera tour
on / off
6 Auto pan on /
off
7 Video
resolution
8 Video
brightness
adjustment
9 Frame rate
adjustment
10 Audio On/Off
11 Video quality
adjustment
Preset: Set up camera to fixed locations before operation
Recall: Drive camera position to preset location
During preset mode, click the number and a dialogue box for
the inquiry of location name input will appear.
Note: It's useful if IR Network Camera is carried by a P/T
scanner. Otherwise, this function is not available.
Preset or Recall camera 1~16 location(s)
Ex. If you press 5, then the camera will move to preset location
5.
Note: It's useful if IR Network Camera is carried by a P/T
scanner. Otherwise, this function is not available.
Turn on or off the camera tour. Camera tour is comprised by
series of preset locations.
Note: It's useful if IR Network Camera is carried by a P/T
scanner. Otherwise, this function is not available.
Turn on or off the auto pan of camera. While auto pan is on, the
camera will swing the camera from leftmost to rightmost tour
and then from rightmost to leftmost cyclically.
Note: It's useful if IR Network Camera is carried by a P/T
scanner. Otherwise, this function is not available.
Adjust Video resolution
Network Camera provides 4 resolutions:
640x480, 352x288, 320x240, 176x144
For NTSC camera: 320x240 is suitable
For PAL camera: 352x288 and 176x144 are suitable
However, all resolution are available for NTSC and PAL camera
Adjust video brightness of camera
Adjust video frame rate via scrolling the listed numbers: 1, 5,
10, 15, 20, 25, 30
Turn on/off audio output function. Note: This function is not
available in Network Camera.
Adjust video quality.
Clarity: Video is better but frame rate may be slower
Fluency: Video is not as good as Clarity but frame rate may be
higher
Default: System default value
21/83