To assemble the fan;
Remove the grille lock nut(4) and fan blade lock nut (2) from the motor
•
shaft(6)
Fit the rear grille by positioning the locating pins in the slots on the grill.
•
Secure the grill to the body with the grille lock nut(4)
Push the fan blade (3) onto the motor shaft (6) positioning the slots on the
•
rear of the blades in the shaft pin on the motor shaft.
Secure the fan blades using the fan blade nut (2), noting that the nut has a
•
left handed thread (turn anti-clockwise to tighten).
Open all the securing clips around the front grille (1) and loosen the
•
securing screw (16).
Line the front grille (1) with the rear grille (4) and press the front grill firmly
•
into position. Close all the clips and tighten the safety screw.
The remote control takes a single CR2032 lithium 3 V button cell. Slide
•
down the battery holder from the bottom rear of the remote control and
insert the battery, taking care to observe the correct polarity as indicated on
battery holder and re-insert the holder.
Before installation select a suitable location for the fan where it is unlikely to
•
cause an obstruction.
Draw a vertical centre line approx. 95mm long on the wall
•
Draw 2 horizontal lines 82mm apart to mark the upper and lower screw
•
holes for the bracket.
On the upper line mark 2 holes 30mm either side of the centre line.
•
Drill holes on the marked points using a 6 mm (¼") masonry bit, and insert
•
the supplied wall-plugs.
2840
Assembly
Installation
30 mm
30 mm
82 mm
3
Ver. 2 - 04/14