Advertisement
CORDED, CORDLESS RECHARGEABLE SPOTLIGHT
& WARRANTY INFORMATION
THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY,
OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USING,
READ AND UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND
PRODUCT LABELS, PLUS YOUR VEHICLE'S BATTERY MANUFACTURER GUIDELINES.
FAILURE TO DO SO COULD RESULT IN INJURY AND/OR PROPERTY DAMAGE.
4140 SW 28th Way, FT. LAUDERDALE, FL 33312
Tel 954-584-4446 • TOLL FREE: 866-584-5504 • Fax 954-584-5556
1,500,000 CANDLEPOWER
WITH BUILT-IN AREA LIGHT
OWNER'S MANUAL
www.vectormfg.com
VEC118S
12/20/02
Advertisement
Table of Contents
Related Manuals for Vector VECTORLITE VEC118S
Summary of Contents for Vector VECTORLITE VEC118S
-
Page 1: Warranty Information
CORDED, CORDLESS RECHARGEABLE SPOTLIGHT WITH BUILT-IN AREA LIGHT & WARRANTY INFORMATION THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USING, READ AND UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND PRODUCT LABELS, PLUS YOUR VEHICLE'S BATTERY MANUFACTURER GUIDELINES. FAILURE TO DO SO COULD RESULT IN INJURY AND/OR PROPERTY DAMAGE. -
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS WARNINGS : Contains non-spillable, sealed, lead acid battery. Must be recycled or disposed of properly. DO NOT dispose of batteries in fire, as this may result in an explosion. DO NOT open battery or short circuit, as this may cause the bat- tery to leak or get hot, causing personal injury. -
Page 3: Additional Features
12 Volt DC power outlet. This allows recharge flexibility for use around home, business or in the field. 12 volt DC power is available from most vehicles, boats, jump starters and portable battery packs. Vector has a variety of portable power products that would make ideal companions. -
Page 4: Operation
3. OPERATION The trigger switch is squeezed to turn on the spotlight. This provides momentary operation. The trigger switch may be locked in the ON position to provide continuous light without continuously squeezing the trigger switch. To lock the trigger switch ON, move the trigger lock to the up position. After use, move the trigger lock down (OFF) and release the trigger switch. - Page 5 4. CHARGING THE VECTORLITE USING AC RECHARGE ADAPTER 1. Locate the recharge port on the side of the spotlight (see figure 1). 2. Connect the charger to an appropriate AC power source. 3. Plug the charger's barrel connecter into the recharge port located near the handle.
-
Page 6: Periodic Maintenance
To replace the H3 type 12 volt bulb, you will need a small Phillips type screwdriver and a replacement bulb (Vector Part VEC190). Bulb life can be shortened by installing a bulb with dirt or fingerprints on it. The bulb can be wiped clean with a cloth moistened with alcohol. - Page 7 FIGURE 3A RETAINING RING RUBBER BEZEL FIGURE 3B 10. Insert the replacement bulb into the reflector's flange. 11. Put back and secure the hairpin retaining wires. 12. Connect the white bulb power wire to the red power wire. 13. Tighten the retaining screw on the flange. 14.
-
Page 8: Replacing The Batteries
10 minutes or less of spotlight operation, they should be replaced with new batteries. To replace the batteries, you will need the Phillips type screwdriver and replacement batteries (Vector Part VEC191). The batteries are in compartments referred to as upper and lower. Because of spotlight construction, there are two procedures;... - Page 9 7. SPECIFICATIONS Spotlight Bulb ....12 volt, H3 series Vector Part No. VEC190 Battery ..... . . Two maintenance free, sealed lead acid, Weight .
- Page 10 30 days of the date of purchase will be replaced free of charge. If such a product is returned more than 30 days but less than two years from the purchase date, Vector Manufacturing will repair the unit or, at its option, replace it free of charge.