Installing The Aid Brackets - Cisco NCS 4016 Manual
Hide thumbs
Also See for NCS 4016:
- Installation manual (85 pages) ,
- Unpacking and installing (8 pages) ,
- Hardware installation manual (82 pages)
Advertisement
Installing the Aid Brackets
Figure 6: Attaching ETSI Brackets to Front
Installing the Aid Brackets
This section explains how to install the aid brackets onto the rack. The aid brackets hold the weight of the
chassis while you secure it in the rack.
Prerequisites
Identify the position of the chassis inside the rack to define the aid brackets position.
Required Tools and Equipment
• Number 1 Phillips screwdriver
• Cisco NCS 4016 installation kit (NCS4K-INST-KIT=)
Steps
SUMMARY STEPS
1. Attach the aid brackets to the rack below where the chassis will sit. Tighten the two screws to firmly attach
the brackets to the rack.
2. Once the chassis has been installed, remove the aid brackets. Loosen the two screws from the aid brackets
and take off the rack.
DETAILED STEPS
Step 1
Attach the aid brackets to the rack below where the chassis will sit. Tighten the two screws to firmly attach the brackets
to the rack.
Securing the Chassis
8
Securing the Chassis
Advertisement
