Using Attachments - Toro TX 1000 Operator's Manual

Figure 26
1. Tow valve
5. Tow the machine as required.
6. After repairing the machine, close the tow valves before
operating it.

Using Attachments

Installing an Attachment
Important: Use only Toro-approved attachments.
Attachments can change the stability and the operating
characteristics of the machine. The warranty of the
machine may be voided if you use the machine with
unapproved attachments.
g031210
Important: Before installing the attachment, ensure
that the mount plates are free of any dirt or debris and
that the pins rotate freely. If the pins do not rotate freely,
grease them.
1. Position the attachment on a level surface with enough
space behind it to accommodate the machine.
2. Start the engine.
3. Tilt the attachment mount plate forward.
4. Position the mount plate into the upper lip of the
attachment receiver plate
g031211
1. Mount plate
5. Raise the loader arms while tilting back the mount plate
at the same time.
Important: Raise the attachment enough to clear
the ground and tilt the mount plate all the way
back.
6. Shut off the engine and remove the key.
7. Engage the quick-attach pins, ensuring that they are
fully seated in the mount plate
Important: If the pins do not rotate to the
engaged position, the mount plate is not fully
aligned with the holes in the attachment receiver
plate. Check the receiver plate and clean it if
necessary.
21
(Figure 27).
Figure 27
2. Receiver plate
(Figure 28).
g003710