Nasotec Alignment Block How To Use

Nasotec Azimuth & VTA Alignment Block
Why we have to use Nasotec Azimuth & VTA Alignment Block?
The diamond tip must be set orthogonally to vinyl for accurate performance. The body of the
cartridge is built orthogonally when the upper lines of the angle are parallel to the surface of the
vinyl. From this angle setting, azimuth is the front line horizontality of the cartridge and vertical
tracking angle (VTA) is the side line horizontality of the cartridge. Our Nasotec Azimuth & VTA
Alignment block is the best tool for easy adjustment.
The level of our Nasotec Azimuth & VTA Alignment Block is to check if your turntable is in balance for
optimal performance and to adjust it if it is needed. So you will have two tools in one.
How to use Nasotec Azimuth & VTA Alignment Block
1. Check the balance of turntable first.
1. Put the Nasotec Azimuth & VTA Alignment Block at platter parallel in front of your turntable.
Check if the bubble of the level is placed at the center. If it is not, raise footers at the opposite
side of the position where the bubble is higher at level until it is balanced.
2. Put the Nasotec Azimuth & VTA Alignment Block at platter parallel to the side of your turntable.
Check if the bubble of the level is placed at the center. If it is not, raise footers at the opposite
side of the position where the bubble is higher at level until it is balanced.
3. Check steps one and two until the turntable is fully balanced.
2. Preparations for azimuth & VTA alignments
1. Put a flat vinyl on your platter. If your record is wrapped, use our Nasotec Outer Ring Clamp and
Nasotec Record Weight to make it really flat. Otherwise, you can use a thin paper for easy balance.
3. Setting of correct azimuth
1. Put the block at the center of the record in the direction of the spindle horizontally using the
level.
2. Swing and place the headshell in front of the block.
3. Lower your headshell on the record by using the lifter.
4. Check the front line of the cartridge if it is parallel to the line of the block.