Sealey PC477 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. safety
1.1. electrIcal safety
WarnIng! it is the responsibility of the owner and the operator to read, understand and comply with the following:
‰
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets and
any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of appropriate
safety devices. A residual current circuit Breaker (rccB) should be incorporated in the main distribution board. We also recommend
that a residual current device (rcd) is used. it is particularly important to use an rcd with portable products that are plugged into a
supply which is not protected by an rccB. if in any doubt consult a qualified electrician. You may obtain a residual current device by
contacting your sealey dealer. You must also read and understand the following instructions concerning electrical safety.
the electricity at Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance tester (PAt), at least once a year.
the Health & safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of those appliances
and the safety of the appliance operators. if in any doubt about electrical safety, contact a qualified electrician.
ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply and use a Portable
Appliance tester.
ensure that cables are always protected against short circuit and overload.
9
regularly inspect power supply cables and plugs for wear or damage and check all
9
connections to ensure that none are loose.
ensure that the voltage marked on the appliance matches the power supply to be used and that the plug is
9
fitted with the correct fuse - see fuse rating.
do not pull or carry the appliance by the power cable.
8
do not pull the plug from the socket by the cable.
8
do not use worn or damaged cables, plugs or connectors. immediately have any faulty
8
item repaired or replaced by a qualified electrician. When an AstA/Bs approved uK
3 pin plug is damaged, cut the cable just above the plug and dispose of the plug safely.
fit a new plug according to the following instructions (uK only).
a) connect the Green/YelloW earth wire to the earth terminal 'e'.
b) connect the BroWn live wire to the live terminal 'l'.
c) connect the Blue neutral wire to the neutral terminal 'n'.
d) After wiring, check that there are no bare wires, that all wires have been correctly connected, that the cable outer insulation extends
beyond the cable restraint and that the restraint is tight.
double insulated products, which are always marked with this symbol
to rewire, connect the wires as indicated above - do not connect either wire to the earth terminal.
Products which require more than 13 amps are supplied without a plug. in this case you must contact a qualified electrician to
ensure that a suitably rated supply is available.
1.2. general safety
disconnect the cleaner from the power supply before servicing, changing accessories, or performing any maintenance.
9
use only genuine parts and accessories. unauthorised parts and accessories may be dangerous and will invalidate your warranty.
9
maintain the cleaner in good condition. use an authorised agent for servicing. Keep machine clean, but do not use solvents.
9
do not operate the unit without a filter in place as this will cause machine faults and will invalidate your warranty.
8
use only the paper cartridge filter specified for dry vacuuming.
9
use only the cloth filter specified for wet vacuuming.
9
Wear protective clothing and gloves.
9
do not allow children or untrained persons to operate the cleaner.
8
do not place attachments close to your face (especially eyes, ears).
8
do not point the hose end at other persons or animals.
8
▲ danger! do not vacuum very fine powders,hot or glowing ash, inflammable,explosive, corrosive or other dangerous substances.
do not leave the machine running unattended, turn power supply off.
8
do not leave the vicinity until motor has come to a complete stop.
8
do not operate the cleaner when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
do not use the cleaner in the rain or in very damp conditions.
8
© Jack sealey limited
instructions for
vacuum cleaners and front mounted
squeegees
Pc477,Pc477aK1
model no:
Original Language Version
, are fitted with live (brown) and neutral (blue) wires only.
Pc477,Pc477AK1.V2 | issue 4 05/12/16
recommended fuse rating
13 Amp