Step 1:
Start by attaching the aluminum uprights to the Patriot Dock
frame, a direct mount on the 4' dimension of the frame (Fig. 1).
Use the M10 x70mm bolts, along with a flat washer under the
head and a split washer under the nut, to attach the uprights to
the aluminum frame. The bolt passes through the upright, 4'
truss and vertical angle of the 8'truss (Fig. 2).
If installing the bench on a dock frame other than Patriot's
frame, it may be easier to install the bench as an assembled
unit to ensure correct spacing of uprights.
Patriot Docks
Bench Kit Assembly Instructions
Part numbers 10832, 10833, 10837, 10936
Fig. 2
www.patriotdocks.com
Required Tool: Phillips driver, 14mm and 17mm
wrench and/or socket
Parts List:
(2) Aluminum Uprights
(2) Aluminum Bench Supports
Aluminum, Cedar or Poly bench covering
Hardware:
(8) M10 x 100mm Bolts (14mm head)
(4) M10 x 70mm Bolts (17mm head)
(12) M10 Nuts, flat washers and split washers
(12) #6 x 1-1/2" phillips head screws
(Cedar and Poly only)
Fig. 1